Coil Type Nozzle Band Heaters

Applications

  • For heating the Nozzles of Injection Molding Machines.
ORDER NOW

Click Here to Read Terms & Conditions

Anupam's nozzle band heaters "COIL TYPE" are capable of performance under the most adverse conditions. Highly recommended for processing high temperature resins to eliminate premature failures due to burn out/ process material leakage.

Heat transfer is based on conduction as well as on radiation principle, which not only improves the thermal efficiency but easy to assemble on nozzles as no pressure on heating surface is essential. Even unskilled operator can fit the heater with no risk of failure of the heater.

Coil Type Nozzle Heaters are specially designed to prevent the failures of heaters against the leakage and contamination of plastic material at nozzle position. This heater can meet the higher temperature requirement prior to moulding at nozzle position.

For heating the Nozzles of Injection Molding Machines.

DESCRIPTION MODEL STANDARD MODEL BRASS LINING
Sheath Material SS / Incoloy SS / Incoloy
Insert - Brass
Wattages 10W/ Sq cm 10W/ Sq cm
Voltage 220/230/240 V 220/230/240 V
Diameter Minimum 25 mm Minimum 25 mm
Length Minimum 25 mm Minimum 25 mm
Thickness 10 mm 12 mm
Working Temp 400° C 500° C
Provision of TC & TC hole Yes Yes

Coil Type Nozzle Heaters -Ordering Information

L Length Of Heater
Ø Inside Diameter Of Heater
  Operating Voltage
  Wattage
  Lead Length